#LaBúsquedaEsContigo

Línea Nacional 018000-117175

Línea Exterior +57-3162783918

Día de la Dignidad de las Víctimas de Crímenes de Estado

Fecha

Mar 06 2022
¡Caducado!

Entradas recientes

Comentarios recientes

Archivos

Categorías

Meta

Únete a la conversación

740 comentarios

  1. kubota v3300-t engine When the water pump shaft and shaft sleeve are worn, the shaft can be electroplated or vibrated back to its original size, and a new standard shaft sleeve can be installed at the same time. The shaft and new sleeve both meet the normal fit clearance requirements. The front and rear bushings should be reamed at the same time as the dumpling hole to guarantee that the two bushings are coaxial. The coaxiality of the two bushings must be less than 0.03mm in most cases. Frequent disassembly and assembly, tightening nut not according to specified torque, or incorrect nut (bolt) of different specifications are all causes of shaft end thread slip or damage. If the damage or slip is limited to two buttons, it may be cleaned by tapping; if there are more than two, it can be manually resurfaced and then turned to the regular size. Cracks in the water pump shaft should be destroyed.

  2. Pingback: 3limousine

Deja un comentario

Translate »
Skip to content